After any degree of side or frontal body damage, inspect the impact crash sensors. Replace a crash sensor if there is any sign of damage.
ВНИМАНИЕ: Take extra care when painting or carrying out bodywork repairs in the vicinity of the crash sensors. Avoid direct exposure of the crash...
Технические приемы
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter can be identified by either of the symbols ISO M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head is also marked with symbols...
In addition to marks identifying the manufacturer, the top of the bolt head is also marked with symbols...
All components should be inspected for wear or damage before reassembling.
Always ensure that component to be inspected is clean and free from oil or grease. When a component is to be checked dimensionally against design specified values, use the appropriate measuring equipment i.e....
Always ensure that component to be inspected is clean and free from oil or grease. When a component is to be checked dimensionally against design specified values, use the appropriate measuring equipment i.e....
Component removal
Whenever possible, clean components and the surrounding area before removal.
Blank off openings exposed by component removal. Following disconnection, seal fuel, oil or hydraulic lines immediately using suitable blanking plugs or caps. Seal open ends of exposed oilways using...
Blank off openings exposed by component removal. Following disconnection, seal fuel, oil or hydraulic lines immediately using suitable blanking plugs or caps. Seal open ends of exposed oilways using...
ВНИМАНИЕ: If the head airbag modules are deployed, the following components must be replaced on the side of the vehicle on which the deployment occurred:
Head airbag modules Link lead between airbag gas generator and restraints control module (RCM) harness Airbag retaining clips Internal...
Head airbag modules Link lead between airbag gas generator and restraints control module (RCM) harness Airbag retaining clips Internal...
ПРЕДОСТЕРЕЖЕНИЕ: Do not fit rear facing child seats in the front passenger seat.
The SRS contains components which are potentially hazardous to service personnel if not handled correctly. The following guidelines and precautions are intended to alert personnel to potential sources of...
The SRS contains components which are potentially hazardous to service personnel if not handled correctly. The following guidelines and precautions are intended to alert personnel to potential sources of...
General
The following guidelines are intended to ensure the safety of the operator whilst preventing damage to the electrical and electronic components of this vehicle.
Equipment Prior to commencing any test procedure on the vehicle, ensure that the relevant test equipment is working...
Equipment Prior to commencing any test procedure on the vehicle, ensure that the relevant test equipment is working...
The following information lists basic precautions which must be observed if fuel is to be handled safely. It also outlines other areas of risk which must not be ignored. As this information is issued for basic guidance only, consult your local Fire Department where any doubt as to personal and...
Always renew oil seals which have been removed either as an individual component or as part of an assembly. Never use a seal which has been improperly stored or handled.
Take great care when removing old seals that the sealing surfaces and seal housing are not damaged. Carefully examine seal...
Take great care when removing old seals that the sealing surfaces and seal housing are not damaged. Carefully examine seal...
When removing or installing flexible hydraulic pipes and hoses, ensure that the following procedures are observed to ensure component serviceability:
Prior to removal, clean area around hose or pipe end which is to be disconnected. Obtain appropriate blanking plugs or caps before...
Prior to removal, clean area around hose or pipe end which is to be disconnected. Obtain appropriate blanking plugs or caps before...