ВНИМАНИЕ: While it is not recommended that a vehicle is jump started, it is recognized that this may occasionally be the only practical way to mobilize a vehicle. Reference should be made to the following and also to the Electrical Section of this manual - Jump Starting.
ВНИМАНИЕ: It is...
Технические приемы
ВНИМАНИЕ: The Restraints Control Module (RCM) will log a crash fault after every impact which is severe enough to cause airbag deployment. It is possible to have three crashes/impacts logged after one event where, for example, a front, side and rollover has occurred. After the third fault is...
ВНИМАНИЕ: If the seat belt pre-tensioners are deployed during a rear impact, the following components must be replaced:
Seat belt pre-tensioners Front and rear seat belt retractors used during the impact Restraints Control Module (RCM) if the three crashes/impacts have been stored
...
Seat belt pre-tensioners Front and rear seat belt retractors used during the impact Restraints Control Module (RCM) if the three crashes/impacts have been stored
...
Always replace locking devices with one of the same design and of the correct size.
Tab washers. Always release locking tabs before loosening fixings, do not re-use tab washers.
Locknuts. Always use a backing spanner when loosening and tightening locknuts, brake and fuel pipe...
Tab washers. Always release locking tabs before loosening fixings, do not re-use tab washers.
Locknuts. Always use a backing spanner when loosening and tightening locknuts, brake and fuel pipe...
ВНИМАНИЕ: If the side curtain air bags are deployed, the following components must be replaced on the side of the vehicle on which the deployment occurred:
Side curtain airbag Any side impact sensors that have been physically damaged or if a fault is being registered Restraints Control...
Side curtain airbag Any side impact sensors that have been physically damaged or if a fault is being registered Restraints Control...
ВНИМАНИЕ: If the front airbags are deployed, the following components must be replaced:
Driver airbag module Passenger airbag module Fly leads (where applicable) connecting front airbag modules to SRS harness Front seat belt buckle pre-tensioner Rear seat belt pre-tensioners - if fitted...
Driver airbag module Passenger airbag module Fly leads (where applicable) connecting front airbag modules to SRS harness Front seat belt buckle pre-tensioner Rear seat belt pre-tensioners - if fitted...
Fuel system hoses
Some fuel hoses are made up of two laminations, an armoured rubber outer sleeve and an inner viton core. Whenever a hose is removed, ensure that the inner bore is inspected to check that the viton lining has not become separated from the outer sleeve.
ПРЕДОСТЕРЕЖЕНИЕ:...
ПРЕДОСТЕРЕЖЕНИЕ:...
When removing and installing bearings, ensure that the following practices are observed to ensure component serviceability:
ВНИМАНИЕ: Service tools have been developed for removing the majority of bearings; these must always be used where specified.
Remove all traces from bearing...
ВНИМАНИЕ: Service tools have been developed for removing the majority of bearings; these must always be used where specified.
Remove all traces from bearing...
The A/C system contains fluids and components which could be potentially hazardous to the service engineer or the environment if not serviced and handled correctly. The following guidelines are intended to alert the service engineer to potential sources of danger and emphasise the importance of...
Correct orientation of cooling system hoses is important to ensure that hoses do not become fatigued or damaged through contact with adjacent components.
Where orientation marks are provided on the hose and corresponding component, the marks must be aligned when the hose is fitted....
Where orientation marks are provided on the hose and corresponding component, the marks must be aligned when the hose is fitted....